The DeLorean Go Tail Light Boards with LED Bulb Kit and Flasher

A pair of brand new, ultimate, 101488 tail light circuit boards, complete with a set of 10 replacement ultra-bright LED bulbs and new LED compatible flasher unit. Our LEDs are the brightest and cheapest of any DeLorean vendor.

Drawing on years of research and testing this is the by far the best tail light board to have ever been made for the DeLorean.

Featuring a weatherproof solder-resistant finish for ultimate longevity, gold-plated contacts for improved and reliable connectivity, and a double-sided connector section (unlike the original) which doubles the contact area with the factory connectors for improved reliability.
The bulb holders used are a high quality, spring loaded type, designed for use equally with the original bulb types or any after-market LEDs using the original bulb base type. Unlike the failure-prone riveted-on originals or soldered on aftermarket replacements these bulb holders are bolted on giving extreme strength and the very best electrical conductivity. No more flickering or unreliable bulbs!
These are the same dimensions as the factory units, so are easy to install.
For owners looking to do a neat UK-style fog-light conversion (which doesn't change the 4-brake-light function) these boards also feature 2 diode installation points on each board, simplifying the installation of our "fog light kit" - otherwise can be ignored for normal use.

By default this kit contains:
8 x Modern very bright warm white LED replacement bulb to suit the brake lights, indicators and reversing lights in the tail light clusters. Uses 27 large (5050) SMD chips to be brighter than stock and only uses 5 watts of power each (compared to 21w originals).
Some people have used red LED bulbs for the brake lights, but in testing we found these bulbs to be much brighter (and just as red!).
2 x Modern bright red LED replacement bulb to suit the (middle) marker lights in the tail light clusters. Uses 27 large (5050) SMD chips to be brighter than stock and only uses 4 watts of power each.
If you haven't already replaced your flasher relay unit (in the front footwell) with a modern LED compatible one, then you will need to replace this with a new one - this is suitable for both normal incandescent bulbs and LEDs, plug and play, no wiring modifications needed. You have a choice of an adjustable-for-flash-speed one, or a non-adjustable one
A complete replacement set of 12x 106272 black stainless screws, 12x 101485 plastic washers, 12x 101486 rubber screw retainers.

Un-tick anything you don't require or already have.