Manual Transmission Roll Pin, Seal and Gasket Kit

A complete set of reinforced roll pins, seals, gaskets and o-rings for the manual/5 speed transmission and drive shafts. All items are available separately - adjust quantities for the ones you don't need. By default the pre-filled quantities are everything in the picture. Kit contains:
- The 9 roll pins on the inside of the transmission, complete with reinforcement pins for each of these to combat the known weakness of this transmission. This includes the shift mechanism selectors, input shaft and reverse spindle.
- (2) SP10090 Roll pin for the flange (also available in stainless)
- (2) SP10090A Reinforcement for the roll pin for the flange (also available in stainless) - used on the inside of the above with the seams on opposite sides as this both reinforces the pin, and helps to stem any minor oil drips from the hole
- (1) 103000 End cover gasket
- (1) 103001 Gasket
- (1) 103049 Selector lip seal
- (1) 103177 Input shaft lip seal
- (1) 103103 Input shaft o-ring
- (2) 103016 Magnetic drain plug
- (1) 103013 Adjuster ring o-ring
- (2) 103120 O-rings for the bearing end of the output shafts
- (2) 104216A Triple lipped drive shaft seal (double lipped version also availble)
- (4) 100119 CV Boot Kit (boots, clamps and grease)
- (1) 100119T Tool for tightening the clamps on these
- (4) 100169R Retaining ring for the CV joint
- (24) SP10013 Upgraded 12.9 grade high tensile zinc coated bolts with a socket cap - makes assembly and removal much much easier than the stock hex cap bolts.
- (24) SP10036 Spring washers

This would be a good time to consider replacing the drive shaft CV joints whilst you have them apart (4 required per car), and if your flange sealing surfaces are pitted we supply a sleeve to repair these (2 required per car).