10 in stock. Usually dispatched today.
$34.99
Overview
Install this kit (by chopping the front radiator bleed hose near the top and putting this T-piece section in) to enable you to much more easily bleed the front section of the cooling system. This kit contains the fittings and (fully stainless) clamps required to splice into your existing front bleed hose, and contains a valve with a short piece of tube to give you the ability to bleed mess-free. A small amount of PTFE tape (available separately) will be required to make the connections water-tight.
Consider this a good time to also replace that bleed hose - for which you will need 1 x 100502 hose (choice of rubber or silicone) and 2 x SP10348 clamps for the ends - see the links at the bottom of the page.
See also our engine area self-bleeder kit.
Consider this a good time to also replace that bleed hose - for which you will need 1 x 100502 hose (choice of rubber or silicone) and 2 x SP10348 clamps for the ends - see the links at the bottom of the page.
See also our engine area self-bleeder kit.
