Under Door Area Floor Lamp Projector Set

Pair of under-door-area logo projectors from D Europe (an unrelated and fully independent aftermarket parts manufacturer/supplier), supplied with a drill bit.

Installation requires drilling 2 holes in the fibreglass tub (underneath the door opening, pointing at the floor - not in the actual door!) and the removal of some inner foam - connect the cables to the door light switch and install the lens with black sealant.
NOT supplied with instructions.
Supplies limited.

You need a little extra space to install the projector, remove the aluminium ring, you don’t need that.
The lens itself can be pulled out of the projector, after it is installed back use some silicone around the outside to keep it clean inside. After drilling the hole, you will need to remove some of the old foam inside the fibreglass, you need this space to put some of the cables in. Lift the inner carpet up near the handbrake, drill a 6mm hole near your hole that you made before, pull the cables in and connect it with the door switch, now use some silicone or black glue to install the projector in place. Test if the angle of the projector is right.