Complete Front Upper Suspension Arms Kit (PAIR)

Complete kit to replace both front suspension upper control arms / wishbones and ball joints and all of the hardware used to hold them on - with all new parts.
These are completely plug and play with no modifications required and operate and fit in the same way as the originals.
Original upper ball joints were originally riveted to the upper arms, replacements are bolted on. These ball joints have 8mm holes, and these arms have 7mm holes (instead of originals at 6.5mm), so our preference is to use 7mm (rather than 6mm) hardware with these arms, which might need some encouragement to get in some of the holes. If you'd rather use the original sized hardware you would need 8xSP10015, 16xSP10031, 8xSP10024 instead.
All items are available separately (as are alternative versions) - change the quantities of the items you don't need to "0" before pressing "add to cart". Kit contains:
(2) 106940B Upper Control Arm - newly made - with brand new rubber 100156 bushings pressed in
(2) 109271 Our upper ball joint, which uses the correct taper and original thread - supplied with rubber boot, castle nut and split pin
(2) 10877PP High tensile Nyloc nut as an optional and easier-to-install version of the above nuts
(8) SP10226 High tensile M7 bolt to hold the ball joints on. These are deliberately a *very* tight fit in the holes in the arms (but preferred since the ball joint holes favour wider bolts)
(16) 102265 Stainless washer for the above bolts
(8) SP10790N High tensile Nyloc nut for the above bolts
(2) 100479 High tensile bolt for holding the arms to the frame
(4) SP10505 Plated steel washer for the above bolts
(8) 100480 Snub washer for the above bolts
(2) SP10059 High tensile Nyloc nut for the above bolts

We also stock a similar kit for the lower front suspension arms.