Página de inicio
Manual Transmission Roll Pin, Seal and Gasket Kit

Manual Transmission Roll Pin, Seal and Gasket Kit

Part No.

K103000

Sea el primero en dejar una reseña para este artículo

Disponible

Vista general

A complete set of reinforced roll pins, seals, gaskets and o-rings for the manual/5 speed transmission and drive shafts.
This is also a good time to replace the drive shaft bolts with our modern DBolt™ upgraded drive shaft bolt set, and you might want to renew the 4 CV boots whilst you are there. This would also be a good time to consider replacing the drive shaft CV joints whilst you have them apart (4 required per car), and if your flange sealing surfaces are pitted we supply a sleeve to repair these (2 required per car).

All items are available separately - adjust quantities for the ones you don't need.
By default the pre-filled quantities are everything in the picture. More details at the bottom of the page.

Elementos de artículos agrupados
Part No.	Nombre del producto	Cantidad
103195	Roll Pin (1 of 4 used per car) 0,40 GBP
103195A	Reinforcement for Roll Pin 0,25 GBP
103219	Roll Pin (1 of 2 used per car) 0,40 GBP
103219A	Reinforcement for Roll Pin 0,25 GBP
7703067082	5th Gear Roll Pin (1 used per car) 0,99 GBP
7703067082A	Reinforcement for 5th Gear Roll Pin (1 used per car) 0,75 GBP
103077	Reverse Spindle Roll Pin (1 used per car) 0,99 GBP
103077A	Reinforcement for Reverse Spindle Roll Pin (1 used per car) 0,75 GBP
103092	Roll Pin 0,99 GBP
103092A	Reinforcement for Roll Pin (1 used per car) 0,75 GBP
SP10090	Differential Flange Pin 0,50 GBP
SP10090A	Differential Flange Pin Reinforcement 0,40 GBP
SP10090SS	Stainless Differential Flange Pin 0,60 GBP
SP10090SSA	Stainless Differential Flange Pin Reinforcement 0,50 GBP
103000	End Cover Gasket (New) 4,50 GBP
103000O	End Cover Gasket (original) 19,99 GBP
103001	Gearbox Gasket 8,99 GBP
103049	Manual Transmission Selector Lever Seal 8,99 GBP
103177	Input Shaft Lip Seal (new) 34,99 GBP
103103	O Ring 0,99 GBP
103016	Magnetic Drain Plug (gearbox) 5,50 GBP
103013	O Ring Seal (Adjuster Ring) 0,99 GBP
103120	O Ring Seal (Final Drive) 0,50 GBP
104216	Drive Shaft Lip Seal - double lipped 9,99 GBP
104216A	Upgraded Triple Lipped Drive Shaft Seal 14,99 GBP
100119	CV Axle Boot Kit 10,99 GBP
100119T	CV Boot Clamp Tool 8,99 GBP
100169R	CV Joint Retaining Ring 1,99 GBP
SP10013	Upgraded M10 Driveshaft Bolt 0,75 GBP
SP10036	M10 Spring Washer 0,20 GBP

Agregar a los favoritos Añadir para comparar

Detalles

A complete set of reinforced roll pins, seals, gaskets and o-rings for the manual/5 speed transmission and drive shafts. All items are available separately - adjust quantities for the ones you don't need. By default the pre-filled quantities are everything in the picture. Kit contains:
- The 9 roll pins on the inside of the transmission, complete with reinforcement pins for each of these to combat the known weakness of this transmission. This includes the shift mechanism selectors, input shaft and reverse spindle.
- (2) SP10090 Roll pin for the flange (also available in stainless)
- (2) SP10090A Reinforcement for the roll pin for the flange (also available in stainless) - used on the inside of the above with the seams on opposite sides as this both reinforces the pin, and helps to stem any minor oil drips from the hole
- (1) 103000 End cover gasket
- (1) 103001 Gasket
- (1) 103049 Selector lip seal
- (1) 103177 Input shaft lip seal
- (1) 103103 Input shaft o-ring
- (2) 103016 Magnetic drain plug
- (1) 103013 Adjuster ring o-ring
- (2) 103120 O-rings for the bearing end of the output shafts
- (2) 104216A Triple lipped drive shaft seal (double lipped version also availble)
- (4) 100119 CV Boot Kit (boots, clamps and grease)
- (1) 100119T Tool for tightening the clamps on these
- (4) 100169R Retaining ring for the CV joint
- (24) SP10013 Upgraded 12.9 grade high tensile zinc coated bolts with a socket cap - makes assembly and removal much much easier than the stock hex cap bolts.
- (24) SP10036 Spring washers

This would be a good time to consider replacing the drive shaft CV joints whilst you have them apart (4 required per car), and if your flange sealing surfaces are pitted we supply a sleeve to repair these (2 required per car).

Más Información