Complete Exterior LED Bulb Kit (including Flasher)

Everything you need to do a complete exterior LED conversion on your DeLorean:

8 x Modern very bright warm white LED replacement bulbs to suit the brake lights, indicators and reversing lights in the tail light clusters. Uses 27 large (5050) SMD chips to be as bright as stock and only uses 5 watts of power each (compared to 21w originals).

Some people have used red LED bulbs for the brake lights, but in testing we found these bulbs to be much brighter (and just as red!).

2 x Modern bright red LED replacement bulbs to suit the (middle) marker lights in the tail light clusters. Uses 27 large (5050) SMD chips to be as bright as the original stock (darker) bulb and only uses 4 watts of power each.

If you haven't already replaced your flasher relay unit (in the front footwell) with a modern LED compatible one, then you will need to replace this with a new one - this is suitable for both normal incandescent bulbs and LEDs, plug and play, no wiring modifications needed. You have a choice of an adjustable-for-flash-speed one, or a non-adjustable one.

2 x Modern bright amber LED replacement bulbs for the front indicators. Our LEDs are the brightest and cheapest of any DeLorean vendor. Uses 27 large (5050) SMD chips to be as bright as stock and only uses 4 watts of power each .

2 x Modern bright amber LED replacement bulbs for the front amber side markers / indicators. Our LEDs are the brightest and cheapest of any DeLorean vendor. Small bulb that fits, and only uses 1 watt of power.

2 x Modern bright red LED replacement bulbs for the rear red side markers. Our LEDs are the brightest and cheapest of any DeLorean vendor. Small bulb that fits, and only uses 1 watt of power. Plug and play.

2 x replacement warm white COB LED bulbs for the 2 license plate lights, using only 0.8 watts of power each. Using the very latest COB LEDs to give the same light output as the original bulbs but at a lot less power. Alternatively we offer an ultra-bright version of these, which gives a slightly whiter (and much brighter) light.

Optionally this would be a good time to replace the screws and rubber gaskets, un-select these if you don't need them, and likewise would be a good time to replace the tail light boards with our ultimate version of these. Drawing on years of research and testing this is the by far the best tail light board to have ever been made for the DeLorean. Featuring a weatherproof solder-resistant finish for ultimate longevity, gold-plated contacts for improved and reliable connectivity, and a double-sided connector section (unlike the original) which doubles the contact area with the factory connectors for improved reliability.
The bulb holders used are a high quality, spring loaded type, designed for use equally with the original bulb types or any after-market LEDs using the original bulb base type. Unlike the failure-prone riveted-on originals or soldered on aftermarket replacements these bulb holders are bolted on giving extreme strength and the very best electrical conductivity. No more flickering or unreliable bulbs!
These are the same dimensions as the factory units, so are easy to install. Un-select these if not required.

All parts are also sold separately.